Toshiba Qosmio G30 HD-DVD (PQG32) User Manual
Page 266
D-4
User’s Manual
TOSHIBA RAID
Starting, Modifying and Ending the BIOS Setup
Program
Starting the BIOS Setup Program
1. Switch on the computer while pressing the Esc key - if the Password
=
prompt is displayed, enter either the Supervisor Password, if one is
set, or the User Password and press the Enter key. Please refer to
Chapter 6, the
for further details about the
User Password.
2. At the Check system. Then press [F1] key. prompt, press the
F1 key - the BIOS setup application will start up.
Modifying the BIOS
1. Select the RAID ARRAY setting in the SYSTEM SETUP (3/3) screen.
2. The settings are explained as follows. Modify the settings as necessary.
Configuration status and settings
Please refer to the operating instructions displayed in the settings screen.
Current State
Shows the current hard disk drive status.
Create State
Modify the hard disk drive configuration.
(Modifications are made with this setting).
Built-in HDD1
Status of the connected hard disk drive.
Built-in HDD2
Status of the second hard disk drive.
JBOD
No RAID settings. Windows cannot be installed
in this disk except for using recovery CD/DVD.
1RAID-0
Set to RAID ready. Windows can be installed in
this disk.
2RAID-0
Set to RAID-0 for 2 hard disk drives.
RAID-1
Set to RAID-1 for 2 hard disk drives (Current
State Only).
UNKNOWN
A RAID status except for the above status and
settings (Current State Only).
No Drive
No hard disk drives connected (Current State
Only).