Toshiba BDX2250 - Manual (Page 14)

14
English
In order to hear the secondary audio, the PIP
feature on the disc must be turned on.
3. Press the PIP button again to turn off the
secondary video.
Primary video
Secondary video
with Secondary Audio
This function is not available when the
primary video is played in Search, Slow-
Motion, or Frame-by-Frame or Fast Forward/
Reverse mode.
To listen to the secondary audio, the digital
audio output must be set to "Bitstream",
"Re-encode" or "PCM". Otherwise, only the
primary audio can be heard.
Notes:
- Not all the Blu-ray™ discs can support this
function.
- High Definition PIP (Second Video) is not
supported.
6 Customizing
This section describes the various setting
option of this Blu-ray Disc TM player.
If the setup option is greyed out, it means
the setting cannot be changed at the
current state.
General Setting
1. Press SETUP button on the remote
control. The Setup Menu appears.
System Screen Saver On
On
On
More...
More...
Language Disc Auto Playback
Playback CEC
Security Load Default
Network Upgrade
General Setting
SETUP Exit
Move cursor key to select menu option
then use “OK” key to select
2. Press  to select an option, then press
 to access.
3. Press / to select a setup option and
press .
4. Select the setting you wish to change
and press OK to confirm.
- Press  to return to the previous menu.
[System]
To change the following system option to
personalize your Blu-ray Disc TM player .
• [Screen Saver]
Turn On or Off the screen saver mode.
It helps to protect the TV screen.
{ On } – Set the screen saver active
after approximately 5 minutes with no
operation. You can turn off the screen
saver by pressing the SETUP button.
- The Blu-ray Disc TM Player will switch to
standby mode if there is no operation
after the screen saver is engaged for
approximately 10 minutes.
{ Off } – Turn off the screen saver
mode.
• [Disc Auto Playback]
Turn On or Off the disc automatic
playback switching mode.
{On} – The disc playback automatically
after loading.
{Off} – Turn off disc auto playback
mode.
• [CEC]
This player supports REGZA-LINK which
uses the HDMI CEC (Consumer
Electronics Control) protocol. You can
use one single remote control to control
all REGZA-LINK-compliant devices that
are connected through HDMI
connectors.
{On} - Turns on REGZA-LINK features.
-With CEC on, during TV standby with
the Blu-ray Disc TM Player on, pressing
SETUP, PLAY/PAUSE will power on the
TV. When you turn the TV off, this unit
will automatically turn off.
{Off} - Disables REGZA-LINK features.
• [Load Default]
Reset all settings of Blu-ray Disc TM Player
to initial default state.
- Follow the instruction on the TV screen
to confirm the default setting operation.
1. Select Load Default.
2. A dialogue box pops up shown as
below. Select OK.
Load Default
Do you want to load default?
OK Cancel