Power supply, Charging a battery pack, Vehicle adapter – Toshiba SDP97 User Manual

Page 5: Turning on/off, Eco mode setting, Playing

Advertising
background image

5

• SD card not formatted in FAT16 or FAT32 cannot be played.
• Connection is not necessarily guaranteed with all USB devices.
• This player is compatible with USB devices that have been formatted with the

FAT16 or FAT32 file systems.

• This player is compatible with USB 2.0.

Power supply

Select one of the following.

AC adapter

Connect the supplied AC adapter to the player, and plug in.

Internal battery pack

See “Charging a Battery Pack” to charge the battery.

Vehicle adapter

See “Vehicle adapter” to connect the supplied vehicle adapter to
a car.

Charging a Battery Pack

Perform a full charge before the first use.

1

Turn the player off. (For powering on/off of this player, see
“Turning on/off”.)

2

Disconnect all cables and cords from the player.

3

Connect the supplied AC adapter only to the player and plug in.

Charging starts. The POWER indicator on the front side illuminates
in orange while charging.
Full charge may take about 5 hours. Do not disconnect the AC
adapter while the indicator illuminates.

Notes

• The battery indicator (

) is shown on the screen when the battery

power is running low.

• Charge the battery with a surrounding temperature of +5°C to +35°C (+41°F to

+95°F).

• Charging will not start if the battery is near full charge.
• Continuous playback time while using the battery is up to approximately 6

hours. For reference purpose only. Not guaranteed. (Conditions: 25°C, Eco
mode is off, output from the headphones, “Background Lightness” set to
“Low”, new product in use.) Low temperature will shorten the playback time.

Vehicle adapter

For DC 12V negative ground only.

1

Turn off the player. (For powering on/off of this player, see
“Turning on/off”.)

2

Turn on the vehicle engine so that the cigarette lighter socket or
power port is powered.

Some vehicles may power the cigarette lighter socket or power
port even when the engine is not running. In this case, you will only
insert the vehicle adapter into it. The power indicator of the adapter
will turn on.

3

Insert the vehicle adapter into the cigarette lighter socket or
power port fully.

4

Insert the cable of the vehicle adapter into the DC IN 12V jack of
the player.

5

Turn on the player.

ON

2

3

4

1

To disconnect

1

Turn off the player.

2

Reverse the order (i.e. 4, 3, then 2) to disconnect the vehicle
adapter then turn off the vehicle’s engine.

WARNING

Do not leave the vehicle adapter connected when you do not use
the player. Neglecting this may cause smoke, fire or electric shock,
because a current will flow through the adapter from the car
battery to the battery of the player.
Be careful especially if your car powers the sockets while the
engine is not running.

Specification

Operating temperature: 5 ~ 35°C (41 ~ 95°F)
Operating humidity: 30 ~ 80%
Storage temperature: -10 ~ 50°C (14 ~ 122°F)
Storage humidity: 20 ~ 80%

Notes

• Strictly follow the above steps when handling the vehicle adapter.
• If the cigarette lighter socket or power port is dirty, be sure to clean it before

connecting the cable of the adapter. Dusts or stains of the cigarette lighter
socket or power port may heat the connected plug while operating, and may
damage the adapter.

• Do not leave the vehicle adapter in an unoccupied vehicle to avoid exposing it

to unusually high ambient temperatures.

Turning on/off

Slide the POWER switch.
The POWER indicator illuminates.
To turn the power off, set to OFF.

Eco Mode Setting

By setting to eco mode, power consumption can be curbed,
saving energy.

1

Press ECO MODE repeatedly.

Each time button is pressed, eco mode is switched.
ON: Enables eco mode. (Screen becomes dark.)
OFF: Enables normal operation. (Screen becomes bright.)

Notes

• The screen brightness will vary when ECO MODE is pressed during AC

adapter operation, and during battery pack operation.

Playing

DVD, VIDEO CD

Open the LCD and slide the OPEN tab to open the disk cover.
Load a disc firmly until a “click” is heard and close the disc cover.
Playback starts. If not, press MODE to select “DVD/CD” mode.

• When loading a DVD video disc that contains a top menu, a menu may

appear. Press

/

/

/

(or number buttons depending on the disc) to

select a content, then press ENTER.

To stop playback

Press STOP ( ).
“Press Play Key To Continue” is displayed. If you press PLAY ( ),
playback resumes.

・ To return to the beginning of the disc, press STOP ( ) on the remote control

twice.

To pause

Press PAUSE/STEP ( / ) on the remote control.
Pressing repeatedly advances frame by frame.

• To resume playback, press PLAY (

).

Fast-forward/fast-reverse playback

Press FWD

(forward) or REV

(reverse).

Fast-reverse or fast-forward can also be switched to by holding
down the (

) or the (

) main unit key.

Pressing repeatedly changes the speed.

• To resume playback, press PLAY (

).

To locate a chapter or track

Press SKIP (

) (next) or SKIP (

) (previous), press

repeatedly.

Slow-motion

While holding SHIFT press SLOW

(forward) or

SLOW

(reverse).

Pressing repeatedly changes the speed.

• To resume playback, press PLAY (

).

To display a top menu (DVD only)

Press QUICK, then select “Top Menu” using the directional buttons
( / ).

Zooming

Press ZOOM repeatedly.
To shift the focus point, press

/

/

/

.

• To resume normal playback, press ZOOM repeatedly until the magnification

display disappears from the screen during playback.

POWER

Advertising