Starting the computer by password, Power-up modes, Starting the computer by password -12 – Toshiba Portege M800 User Manual
Page 113: Hot keys
User’s Manual
6-12
Power and Power-Up Modes
Starting the computer by password
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3,
. The
following message appears:
2. Enter the password.
3. Press Enter.
or if available
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint Power On
Security. If you would not like to swipe your finger or cannot authenticate
the fingerprint for some reasons, push the BkSp key to skip the fingerprint
authentication screen. You can try to swipe the fingerprint up to five times.
If you failed fingerprint authentication more than five times, you must enter
the password manually to start the computer.
Power-up modes
The computer has the following power-up modes:
■
Boot Mode: Computer shuts down without saving data. Always save
your work before you turn the computer off in boot mode.
■
Hibernation Mode: Data in memory is saved to the hard disk.
■
Sleep Mode: Data is maintained in the computer's main memory.
Hot keys
You can use hot keys Fn + F3 to enter Sleep Mode and Fn + F4 to enter
Hibernation Mode. Refer to Chapter 5,
for details.
Password=
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Refer also to the sections
and
in Chapter 3,