Toshiba RV753 User Manual
Page 71
71
PROBLEM SOLVING
E
n
g
lish
a
Set the Colour to Auto and exit.
b
Go to the PICTURE menu and adjust the tint.
Q
What is DVB-T?
A
Digital Video Broadcast via an aerial/antenna.
Q
What is DVB-C?
A
Digital Video Broadcast via a cable connection.
Q
How are radio channels selected?
A
Press TV on the remote control and select DTV
RADIO. Alternatively select from the GUIDE.
Q
What can be done if the PIN number has been
forgotten?
A
Use the Master PIN code of 1276, then change to a
number of your choice. Select PIN Settings from the
DTV Setting menu to enter PIN. Ensure that no-one
else can use the Master PIN by removing the Owner’s
Manual.
Q
Why are there vertical stripes on the screen when in
PC mode?
A
The Sampling Clock may need adjustment. Select PC
Settings from the Display Settings menu, highlight
Sampling Clock and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
The Clock Phase may need adjustment. Select PC
Settings from the Display Settings menu, highlight
Clock Phase and adjust until the picture clears.
Q
Why when digital subtitles have been selected are
they not showing on screen?
A
Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the main index page of the text service
and look for the User Guide. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text see the text section.
Q
Why is a page number visible at the top of the screen
but no text?
A
Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select Colour System from the SETUP menu.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 10).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try switching the HDMI settings (Enable
Content Type and INSTAPORT™) to Off.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed the settings of
the device, turn off your television and unplug the
power cord, and then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK device is disconnected, the logo will
disappear after approximately one minute.
Q
Why don't the networked devices work?
A
The LAN cables are not connected properly or at all.
Connect all cables (see page 13).
Make sure your network address is set up correctly
(see page 36).
Q
Why doesn't the wireless network work?
A
Make sure the TOSHIBA Dual Band WLAN Adaptor is
used (see page 13).
Check that the AP is powered on.
WL75_WebOM_UK.book Page 71 Thursday, June 17, 2010 7:10 PM