Toshiba Tecra A7 - Manual (Page 150)

User’s Manual 9-20
Troubleshooting
Standby/Hibernation
LAN
Wireless LAN
If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4,
Operating Basics .
Character display
becomes garbled
during a communication
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Problem Procedure
The system will not
enter Standby/
Hibernation
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select Standby/
Hibernation.
If problems persist, contact your dealer.
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adaptor is connected.
The does not work Wake-up on LAN function
consumes power even when the system is off.
If problems persist, consult your LAN
administrator.
Problem Procedure
Problem Procedure
Cannot access
Wireless LAN
Make sure the computer’s wireless
communication switch is set to on.
If problems persist, consult your LAN
administrator.