Removing a memory module – Toshiba Satellite L830 User Manual

Page 75

Advertising
background image

8.

Seat the memory module cover in place and secure it with the screws.

Take care to ensure that the memory module cover is firmly closed.

Figure 3-14 Seating the memory module cover

2

2

1

1. Memory module cover

2. Screws

9.

Install the battery pack - refer to

Replacing the battery pack

section in

Chapter 5, Power and Power-Up Modes, if required.

10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized

- to confirmed it,click Start -> Control Panel -> System and Security
-> System
icon.

Removing a memory module

To remove the memory module, follow the steps as detailed below:
1.

Shut down the computer - make sure the Power indicator is off (refer
to the

Turning off the power

section in Chapter 1, Getting Started if

required).

2.

Remove the AC adaptor and all cables and peripherals connected to
the computer.

3.

Close the display panel.

4.

Turn the computer upside down and remove the battery pack.

5.

Loosen the screws securing the memory module cover in place -
please note that the screws are attached to the cover in order to
prevent them from being lost.

6.

Slide your fingernail or a thin object under the cover and lift it off.

7.

Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.

L830/L835

User's Manual

3-37

Advertising
This manual is related to the following products: