Toshiba Tecra W50-A - Manual (Page 91)

9. Install the battery pack - refer to Replacing the battery pack section, if
required.
10. Turn your computer over.
11. Turn the computer on and make sure the available memory is
recognized - to confirmed it, click Desktop -> Desktop Assist -> Control
Panel -> System and Security -> System.
Installing/Removing a memory module (Slot C/D)
To install/remove a memory module (Slot C/D), follow the steps as detailed
below:
1. Click Power in the Settings charm, and then click Shut down while
holding down the SHIFT key - ensure that the Power indicator is off.
2. Disconnect the AC adaptor, all cables, and any peripheral connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section, if required).
5. Remove the following KB screw used to keep the keyboard secure on
the underside of the computer.
Figure 4-15 Removing the KB screw
1
1. KB screw
Product appearance depends on the model you purchased.
6. Turn your computer over and open the display panel.
7. Slip your fingernail or a thin object under the notch at the end of the
keyboard brace and lift it up to release latches and remove the keyboard
brace.
User's Manual 4-38