Toshiba CV711 - Manual (Page 19)

English
SETTING UP
18
Switching on
Before switching on the television, make sure to connect the aerial cable, and select TV as the input
source.
If the RED LED is off, check that the mains plug is connected to the power supply. If the picture does
not appear, press on the remote control, it may take a few seconds to appear.
To put the television into Standby mode, press on the remote control. To view the picture, press
again. The picture may take a few seconds to appear.
Using the remote control
To set up the television, you need to use the on-screen menus. Press on the remote control to see
the menus.
The on-screen menu appears as a list of five topics. As each symbol is selected by pressing ◄ or ►on
the navigation ring on the remote control, its respective options will appear below.
To use the options, press  or  on the navigation ring to move up and down through them and use
, ◄ or ► to select the required choice. Follow the on-screen instructions. The functions of each
menu are described in detail throughout the manual.
Using the side-panel controls
To alter the volume, press – +.
To alter the programme position press  P .
Press MENU and , , or to control the sound and picture options. Press MENU to finish.
To select the external input, press to move through the list until the appropriate input source is
selected as described on page 35.
Please always refer to the owner’s manual of the equipment to be connected for full details.