Toshiba Slim Port Replicator III - Manual (Page 13)

User’s Manual EN-13
Slim Port Replicator III
The Slim Port Replicator III is now ready for use.
Disconnecting the Slim Port Replicator III
To disconnect the Slim Port Replicator III, follow the steps below and save
all your work first.
1. Slide the Computer lock switch to the unlock position:
Figure 2-4 Sliding the Computer lock switch
2. Make sure you perform one of the following:
n Perform any software disconnect operation required by the
operating system.
n Turn off the computer’s power in any mode: boot, suspend or
hibernation.
n Press the eject button on the Slim Port Replicator III.
Figure 2-5 Pressing the Eject Button
When the Slim Port Replicator III is connected to the computer
successfully, the docking LED will glow blue if the computer is turned
on.
NOTE
Make sure the Docking LED is out. Do not try to disconnect the
computer while the Docking LED is glowing.
CAUTION