Toshiba BL712 - Manual (Page 13)

English - 12 -
English
Controlling the TV
A wide variety of external equipment can be connected via the sockets located on the side and back of the
television. Whilst all the necessary adjustments and controls for the television are made using the remote
control, the touch controls on the left side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the standby/on button on the
the television to switch the television on. Then the LED lights
up red. If the picture does not appear, press standby/on on
the remote control; it may take a few moments.
To put the television into Standby, press standby/on on the
remote control. To view the television, press standby/on again.
The picture may take a few seconds to appear. Note: The
active Standby LED may appear for a few moments when
the TV is switched off.
Note: A beeping sound will be heard when the touch
buttons are touched. This is normal operation, not
a fault and can also be heard when the set is in
standby.
For energy saving:
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This
is recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy
use.
NOTE: Putting the television into standby mode, will reduce
energy consumption, but will still draw some power.
Using the Remote Control
Press the MENU button on the remote control to see the
menus.
The main menu appears as a group of icons each for a menu
option. Press the Left or Right button to select a topic.
In sub menu screen mode the menu appears as a list. Press
the Up or Down button to select a topic.
To use the options press the and buttons on the remote
control to move up and down through them and OK, or
buttons to select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
Using the Controls and Connections on the TV
Using the control buttons on the front of the TV:
• To alter the volume press “ ”/ “ ”.
• To alter the programme position press - P/CH + on the left
side of the TV.
• Press “ ”/ “ ” buttons at the same to view main
menu and use - P/CH + to navigate and “ ”/ “
” to change value.
To select an external input, press TV/AV until the appropriate
input source is selected.
Please always refer to the owner’s manual of the equipment
to be connected for full details.
IR receiver /Standby LED
Menu OSD
Volume
Down/Up
Programme
Down/Up
AV/
Source
Standby
/I
A01_MB65_[GB]_(IB_QSG)_DVB-TC_(3910UK_46975LED)_GOLD14_10079756_50224163.indd 12 A01_MB65_[GB]_(IB_QSG)_DVB-TC_(3910UK_46975LED)_GOLD14_10079756_50224163.indd 12 28.07.2012 10:19:27 28.07.2012 10:19:27