Toshiba Camileo X200 - Manual (Page 10)

10
EN
Section 2
Getting Started
Loading the Battery
The battery comes pre-installed in the camcorder, however
you must remove the insulator on the battery before use.
1. Slide the safety latch and open the battery cover.
2. Remove the battery from the camcorder and pull the
insulator off.
3. Insert the battery according to the correct polarity marks
(+ or -).
4. Close the battery cover firmly.
Charge your battery
You must use the supplied AC charger or the USB cable.
The camcorder must be turned OFF. A blinking light indicates
active charging and a solid light indicates that charging is
complete. In AC charging mode, the full charging time is
about 4- 5 hours and the light will turn off automatically after
3~5 minutes. (Actual charging time may vary. It depends on
the battery condition.)
REMOVE