Nokia 6210 Navigator - Manual (Page 24)

23
2. To change between showing video or only hearing sound during a video call, select from
the toolbar Enable video sending or Disable video sending.
If you have denied video sending during a video call, the call is still charged as a video call.
Check the pricing with your network operator or service provider.
3. To end the video call, press the end key.
Answer a video call
When a video call arrives, is displayed.
To answer the video call, press the call key. Allow video image to be sent to caller? is shown.
If you select Yes, the image captured by the camera in your device is shown to the caller.
Otherwise, video sending is not activated.
If you have denied video sending during a video call, the call is still charged as a video call.
Check the pricing with your service provider.
To end the video call, press the end key.
■ Call settings
Call
Select > Settings > Phone sett. > Phone > Call and from the following:
Send my caller ID (network service) — to display or hide your phone number from the person
to whom you are calling
Call waiting (network service) — See ”Call waiting,” p. 22.
Decline call with msg. and Message text — See ”Answer or reject a call,” p. 22.
Own video in recvd. call— to set whether you allow to send your own video image when you
receive a video call
Image in video call — to select a still image to be shown when you deny a video call
Automatic redial — to set your device to make a maximum of 10 attempts to connect the
call after an unsuccessful call attempt
Show call duration and Summary after call — to set the device to display the call duration
during a call and the approximate duration of the last call
1-touch dialing — See ”1-touch dialing,” p. 21.
Anykey answer — to answer an incoming call by briefly pressing any key, except the left and
right selection keys, volume keys, and end key
Line in use (network service) — to select the phone lines for making calls and sending short
messages. This is shown only if the SIM card supports two phone lines.
Line change (network service) — to enable or disable the line selection