Bolens 452 Thru 465 - Manual (Page 9)

9
3
Setting Up
Your Chipper
Shredder
Figure 3-10
A
B
C
Figure 3-9
NOTE: All references
in this manual to the
left or right side of
the chipper shredder
is from the operating
position only. Excep-
tions, if any, will be
specified.
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Be
certain to service
engine with gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
NOTE: This Operators
Manual covers a range
of product specifica-
tions for various
models. Characteristics
and features discussed
and/or illustrated in this
manual may not be ap-
plicable to all models.
MTD LLC reserves the
right to change product
specifications, designs
and equipment without
notice and without
incurring obligation.
9. a. Align the chipper chute over the weld studs, so the
slot in the bottom of the chute is facing down.
b. Secure chipper chute with the three cupped
washers (cupped side against the chipper chute)
and hex nuts previously removed. Tighten the nuts
at this time. See Figure 3-9.
Attaching The Bag
10. To attach the bag:
a. Place the opening of the bag completely over the
chute deflector.
b. Pull on the drawstring until the bag is tight around
chute deflector opening.
c. Clip drawstring back on itself, tight against chute
deflector to secure into position. See Figure 3-10.