Nokia 6230 - Manual (Page 71)

58 Copyright © 2004 Nokia
Automate voice mail
You can insert special characters called dialing codes into phone numbers such as
voice mail and then save the number to a 1-touch dialing location. Dialing codes
instruct the receiving system to pause, wait, bypass, or accept the numbers that
follow them in the dialing string.
Note: Each voice mail service can vary. The examples and steps that follow
are for clarification. Check with your service provider if you have specific
questions about your voice mail service.
WRITE DOWN SOME INFORMATION
You will need this information in “Dialing codes setup” on page 58. Be sure to
record all of the information correctly.
1 Write down your voice mailbox number.
2 Call and check your voice mail as you normally would.
3 Write down your interaction with the recorded prompts step-by-step. Keep in
mind that each voice mail service may vary. However, it should look something
like this:
Dial 2145551212, pause 5 seconds, press 1, pause 2 seconds, press 1234, press
pound key.
DIALING CODES SETUP
1 From the menus, select Contacts > 1-touch dialing.
2 Scroll to an empty 1-touch dialing slot, and select Assign.
3 Enter your voice mailbox number, including the area code.
4 Enter any dialing codes as necessary.
For example, if you pause for 5 seconds after connecting to voice mail, enter
p twice after the voice mailbox number, such as 2145551212pp.
See “Insert dialing codes” on page 59.
5 Enter any remaining pauses, PIN codes, and other information that allows you
to listen to your messages, and select OK.
6 Enter a name (such as Voice Mail), and select OK.
A message appears in the display confirming your 1-touch dialing location has
been saved.
7 To dial and listen to your voice mail, press and hold the assigned 1-touch
dialing key at the start screen.
No other keypresses should be necessary to connect and listen to your
messages.