Brother XC6771-021 - Manual (Page 19)

17
1
4
While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
5
Trim the excess thread above the bobbin.
6
Press the foot controller to start.
7
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller.
8
Cut the thread, slide the bobbin winder shaft
to the left and remove the bobbin.
Note
● The needle bar does not move when you
slide the bobbin winder shaft to the right.
● Immediately after winding the bobbin, it is
normal to hear the sound of the clutch
engaging when beginning to sew or turning
the handwheel.
● Make sure you follow the instructions
carefully. If you do not cut the excess
thread completely before winding the
bobbin, when the thread runs low it may
tangle around the bobbin and cause the
needle to break.
● Not winding the bobbin properly may
cause the thread tension to loosen, and
may break the needle.
1 Wound evenly
2 Wound poorly
CAUTION
CAUTION
1 2
XL2600.book Page 17 Thursday, November 4, 2004 9:46 PM