Nokia N93 - Manual (Page 103)

Tools
102
Authentication —Select Normal or Secure .
Homepage —Depending on the access point you are setting
up, enter the web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type —Select IPv4 settings or IPv6 settings .
The other settings depend on the selected network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address —In Primary name serv.: , enter the IP address
of the primary DNS server. In Second. name server: , enter
the IP address of the secondary DNS server. Contact your
internet service provider to obtain these addresses.
Proxy serv. address —Define the address for the proxy server.
Proxy port number —Enter the proxy port number.
Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name —Select Enter manually or Search for
netw. . If you select an existing network, WLAN netw. mode
and WLAN security mode are determined by the settings
of its access point device.
WLAN netw. mode —Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode —Select the encryption used: WEP ,
802.1x (not for ad hoc networks), or WPA/WPA2 . If you
select Open network , no encryption is used. The WEP, 802.1x,
and WPA functions can be used only if the network
supports them.
WLAN security sett. —Enter the settings for the selected
security mode:
Security settings for WEP are as follows:
Wep key in use —Select the WEP key number. You can create
up to four WEP keys. The same settings must be entered on
the wireless LAN access point device.
Authentication type —Select Open or Shared for the
authentication type between your device and the wireless
LAN access point device.
WEP key settings —Enter WEP encryption (length of the
key), WEP key format ( ASCII or Hexadecimal ), and WEP
key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2 are as follows:
WPA mode —Select the means of authentication: EAP to
use an extensible authentication protocol (EAP) plug-in or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP )—Enter the settings as
your service provider instructs.