Connection settings, See “line in use (network service) – Nokia 6600 User Manual
Page 79
Nokia 6600 User Guide
66
Copyright © 2004 Nokia
AUTOMATIC REDIAL
•
When this setting is activated, your phone will make a maximum of ten attempts
to connect the call after an unsuccessful call attempt. Press to stop
automatic redialing.
SUMMARY AFTER CALL
•
Activate this setting if you want the phone to briefly display the duration of
the last call.
1-TOUCH DIALING
•
Select
On
and the numbers assigned to the 1-touch dialing keys (
-
)
can be dialed by pressing and holding the key. See “Assigning 1-touch dialing
keys” on page 25.
ANYKEY ANSWER
•
Select
On
, and you can answer an incoming call by briefly pressing any key,
except , ,
and
.
LINE IN USE (NETWORK SERVICE)
•
This setting is shown only if the SIM card supports two subscriber numbers,
that is, two phone lines. Select which phone line (
Line 1
or
Line 2
) you want to
use for making calls and sending short messages. Calls on both lines can be
answered irrespective of the selected line.
Note: You will not be able to make calls if you select
Line 2
and have not
subscribed to this network service.
To prevent line selection, select
Line change
→
Disable
if supported by your SIM
card. To change this setting, you need the PIN2 code.
Connection settings
GENERAL INFORMATION ABOUT DATA CONNECTIONS AND
ACCESS POINTS
Access point - The point where your phone connects to the Internet by way of a
data call or packet data connection. An access point can be provided, for example,
by a commercial Internet service provider (ISP), service provider.
To define settings for access points, go to
Settings
→
Connection
→
Access points
.
A data connection is required to connect to an access point. Your phone supports
three kinds of data connections:
•
a GSM data call (
),
•
GSM high-speed data call (
), or
•
packet data (GPRS) connection (
).