Nokia Advanced Car Kit CK-7W - Manual (Page 16)

I n s t a l l a t i o n
16
Some vehicles do not come with an IGNS connection. This line is not
necessary for operation of the Advanced Car Kit; the blue wire can be
left unconnected. However, in this case, the Advanced Car Kit does
not switch off automatically when the ignition is turned off. To
prevent accidental draining of the car battery, the Advanced Car Kit
automatically switches off after two minutes unless a mobile phone
is connected over Bluetooth wireless technology or the data cable.
• Connect the red wire to the positive terminal of the 12V car battery
using the 2A fuse supplied.
The four-pin plug of the cable set is plugged into the "DC" port of the
handsfree unit.
Data cable
The data cable connects the handsfree unit with a compatible mobile
phone, i.e. via the phone holder.
Plug one end of the cable into the "PHONE" socket in the handsfree unit
and the other into the phone holder.
If the Advanced Car Kit is to be used only with Bluetooth wireless
technology, the data cable does not need to be connected.
Charger cable
The charger cable allows you to charge a compatible mobile phone
while it is connected to the Advanced Car Kit over Bluetooth wireless
technology.
The charging cable can be used with compatible Nokia devices that have
a 2.0-mm charger connector.
■ Function test
After your Advanced Car Kit has been installed, it needs to be checked to
ensure that it is working properly. When testing the operation of the
equipment, also check that it has been mounted so that it in no way
impairs the driver during operation of the vehicle.