Assembling grass catcher, Attaching grass catcher to mower – Bolens 416 User Manual

Page 8

Advertising
background image

8

bracket (carriage bolt must go to the inside of
handle). Secure with one plastic wing nut, also
included in the hardware pack. Repeat on the other
side with remaining items from the hardware pack.

The rope guide is attached to the right side of upper
handle. Loosen the wing nut which secures the
rope guide.

With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope out of the
engine. Release the blade control handle. Slip the
starter rope into the rope guide. Tighten the wing
nut. See Figure 5.

Tighten all nuts and bolts securely.

Figure 5

Insert post on cable ties into holes provided on the
lower handle. Pull the cable tie tight and trim the
excess. See Figure 6 .

Figure 6

Assembling Grass Catcher

NOTE: Make certain bag is turned right side out before
assembling (warning label will be on the outside).

Parts for Grass Bag:

1.

Frame Assembly

2.

Grass bag

Assemble grass bag as follows:

Place bag over frame (black plastic side is the
bottom of bag). Slip the openings in the side of the
plastic channel on bag over the hooks on the frame.

Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7B.
All of the plastic channels except center top of bag

attach from the outside of bag. Center top of bag
attaches from the inside of bag.

Figure 7

Attaching Grass Catcher To Mower

Lift the rear discharge door and place the grass
catcher on the pivot rod. Let go of discharge door
so that it rests on the grass catcher. See Figure 8.

Figure 8

To remove the grass catcher: Lift the rear
discharge door on the mower as shown in Figure 8.
Lift the grass catcher up, out of the slots in the
handle bracket assemblies. Release the rear
discharge door.

Converting To Mulcher

Lift the rear discharge door on the mower and
remove the grass catcher. Release the discharge
door to allow it to close the rear opening of the
mower. Now it is ready to mulch.

Slip rope into
rope guide

Wing Nut

Rope
Guide

Cable Tie

Lower
Handle

Hole on

Post

WARNING:

Never operate mower unless

the hooks on the grass catcher are firmly
seated in the slots on the handle bracket
assemblies, and the rear discharge door rests
firmly against top of the grass catcher.

Bag

Hook

Plastic

Channels

Grass

Rear Discharge
Door

Grass
Catcher

Advertising