Bad Boy Mowers BAD BOY 02.9812.0001C - Manual (Page 74)

B AD B OY ™ S POT L UMINAIRE U SER M ANUAL
6 4 02.9812.0001C
Cleaning the Enclosure Intake Filters
The intake filters should be cleaned or replaced when they are dirty. The frequency will depend on how
often and in what conditions the luminaire is used.
Tools and Supplies:
#2 Phillips screwdriver
Compressed air and/or water
To clean enclosure intake filters:
WARNING: Remove power from luminaire before performing any maintenance procedures.
Step 1. Remove power from luminaire.
Step 2. Remove Intake Cover by first loosening two captive screws, then pulling away from Upper
Enclosure as shown in Figure 4-5 .
Figure 4-5: Removing Enclosure Intake Filters
Step 3. At retainer, remove four 6-32 x 1/2" PPZ screws.
Step 4. Remove intake filter.
Step 5. Clean filter with compressed air and/or by washing with water.
Step 6. Re-install components.
Step 7. Repeat for second intake filter.
Parts:
40-9812-0834 2 EA AIR INTAKE FILTER
Intake Cover
Captive Screws
Upper Enclosure
Mesh Cover
Intake Filter
Retainer
6-32 x 1/2"
Intake Filter
PPZ Screw (4)
NOTE:
If the filters do not get clean after multiple
attempts, they should be replaced.