Braun 750CC-5 - Manual (Page 29)

29
Rinsing the shaving head under running water
is an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the release
button to remove the Foil & Cutter cassette
and let it dry.
• If you regularly clean the shaver under water,
apply a drop of the light machine oil, included
with the shaver, onto the shaver foil and
long hair trimmer. This is critical for proper
functioning of the shaver as washing under
water can lead to removal of lubricants from
the shaver’s cutting parts leading to higher
friction in the shaver. This may result in the
battery running out faster than normal. Even
if this happens – indicated by low charge
indicator lighting up earlier, your Braun shaver
will run for at least 5 more minutes enabling
you to complete your current shave.
Alternatively, you may clean the shaver using the
brush provided:
• Switch off the shaver. Remove the Foil & Cutter
cassette and tap it out on a fl at surface.
Using the brush, clean the inner area of the
pivoting head. However, do not clean the
cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button to open the
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.
oil
trim
m
er
er
release
trimmer
release
release
click!
Series 7
Series 7
Series Series
release
release release
Series 7
Series 7
new old