Beko D1 5062 B - Manual (Page 20)

EN 20
steadily after 1-2 minutes if the water
level in the machine is suitable. Laundry
may be added or taken out by opening
the door. If the “Lid” lamp does not
light up continuously at the end of this
time, the water level in the machine
is not suitable and laundry cannot be
added. You can resume the program
by pressing the “Start/Pause/Cancel”
button again.
Child-proof lock
There is a childproof lock to prevent
any program interruption because of
pressing the keys while the program is
on. In order to activate the childproof
lock, press on the 1st and 2nd
auxiliary function keys from the left
simultaneously for 3 seconds after
the washing program has started.
1st auxiliary function light will flash
continuously.
To start a new program after the
program is over or to interfere the
program, childproof lock should be
deactivated. To deactivate the child-
proof lock, press the same buttons for
3 sec.
Ending the program through
canceling
The program which is selected first will
keep on going even if the position of the
program selection button is changed. A
new program can be selected or started
after “Program is cancelled” in order to
change the washing program.
To cancel any selected program;
• Press “Start/Pause/Cancel” button
for 3 seconds. The machine starts
to discharge the water. “Wash” and
“Program Finished” lights will light
up.
• "Start/Pause/Cancel" and “Wash”
lights will go off after discharging
process is over and the “Lid” light
will start flashing.
• “Lid” lamp will light up continuously
when the door is unlocked. You can
select and start a new program.
• If the program is cancelled in the
middle of the process, “Wash”
and “Program Finished” lights will
light up. The machine can drain
all the water or can take in water
for 3 times at most to cool down
the clothes and complete draining
process.
• When the water discharging process
is completed, the “Wash” light will
go off, “Program Finished” light
will light up and the “Lid” light will
continuously flash until the door
is unlocked. You can make a new
program selection when the “Lid”
light is illuminated continuously.
End of Program
The “Program Finished” lamp on the
program follow-up indicator will light up
when the program comes to an end.
The lid is unlocked 2 minutes later, the
“Program Finished” and “Lid” lamps will
light up continuously. The machine is
now ready for a second cycle.
If any key is pressed when the machine
is at the end of the program or if
the position of the selection knob is
changed, the “Program Finished” light
will go off and only the “Lid” lamp will
remain as lit. Meanwhile, if the door is
still locked, the “Lid” light will continue
flashing until the door is opened.
Press the “On/Off” button to shut down
the machine.