Brother HL-2030 - Manual (Page 10)

About this printer
1 - 3
1
Positioning the printer
Please read the following before you use the printer.
Power supply
Use the printer within the recommended power range.
Power source: USA and Canada: AC 110 to 120 V, 50/60 Hz
Europe and Australia: AC 220 to 240 V, 50/60 Hz
The power cord, including extensions, should not be longer than 5 meters (16.5 feet).
Do not share the same power circuit with other high-power appliances, such as an air conditioner, copier,
shredder and so on. If you cannot avoid using the printer with these appliances, we recommend that you use
a voltage transformer or a high-frequency noise filter.
Use a voltage regulator if the power source is not stable.
Environment
■ You should setup the printer near a power outlet that you can easily reach, so that it can be easily
unplugged from the power outlet if there is an emergency.
■
Only use the printer within the following ranges of temperature and humidity:
Temperature: 10 °C to 32.5 °C (50 °F to 90.5 °F)
Humidity: 20% to 80% (without condensation)
■
You should use the printer in a well-ventilated room.
■
Put the printer on a flat, horizontal surface.
■
Keep the printer clean. Do not put the printer in a dusty place.
■
Do not put the printer where the ventilation hole of the printer is blocked. Keep a gap of approximately 100
mm (4 in.) between the ventilation hole and the wall.
■
Do not put the printer in direct sunlight. If you have to put it near a window, use a blind or a heavy curtain
to protect the printer from direct sunlight.
■
Do not put the printer near devices that contain magnets or generate magnetic fields.
■
Do not subject the printer to strong physical shocks or vibrations.
■
Do not expose the printer to open flames, salty or corrosive gasses.
■
Do not put objects on top of the printer.
■
Do not put the printer near an air conditioner.
■
Keep the printer horizontal when you carry it.