Remote control effective range, Installing or replacing the battery – BenQ PB6210 User Manual
Page 15
Introduction
11
Remote Control Effective Range
Infra Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote
control sensors to function correctly. The distance between the remote control and the sen-
sors should not exceed 6 meters (19.5 feet).
Notes on Remote Control Operation:
Make sure that there are no obstacles between the remote control and the IR sensors on the
projector that might obstruct the infra-red beam.
Installing or Replacing the Battery
1.
Pull out the battery holder.
2.
Insert the new battery in the
holder.
3.
Push the holder into the
remote control.
Avoid excessive heat and humidity.
There may be danger of an explo-
sion if the battery is incorrectly
replaced. Replace only with the
same or equivalent type recom-
mended by the manufacturer. Dis-
pose of the used battery according
to the manufacturer’s instructions.
Preset
According to the selected input signal, there are several picture
setup options available: Vivid mode, Presentation mode, Gaming
mode, Video mode, Cinema mode and Economic mode. Refer to
page
for more information.
6m