Neff T93T42N2MK - Manual (Page 34)

34
Changing the basic settings
The hob must be switched off.
1. Switch on the hob.
2. Within the next 10 seconds, touch the 3 symbol for
4 seconds.
™‚ appears in the timer display and ‹ in the hotplate display.
3. Touch the 3 symbol repeatedly until the desired symbol
appears in the timer display.
4. Set the desired value using the twist knob.
5. Touch the 3 3 symbol for 4 seconds.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
Cleaning and care
The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.
Ceramic
Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for glass ceramic.
Follow the cleaning instructions on the packaging.
Never use:
■
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain remover
■
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.
Using special sponges to clean glass ceramic achieves great
cleaning results.
Hob surround
To prevent damage to the hob surround, observe the following
instructions:
■
Use only hot soapy water.
■
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
Do not use the glass scraper.
™‡ Duration of the timer end signal
‚ 10 seconds.
ƒ n 30 seconds
„ 1 minute.*
™ˆ Activation of the filament circuits
‹ Switched off.*
‚ Switched on.
ƒ Last setting before the hotplate was switched off.
™‰ Operation without twist knob
‹ Switched off
‚ Switched on*
™‹ Reset to basic setting
‹ Switched off.
‚ Switched on.
Indicator Function
*Basic setting