Briggs & Stratton 20228 - Manual (Page 11)

11
How to Use ProjectPro™ Nozzle
System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro™ system nozzles.
The ProjectPro™ nozzles vary the pressure and spray
pattern as shown (Figure 12).
Follow these instructions to change ProjectPro™
nozzles:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick–connect and pull current
ProjectPro™ nozzles off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
3. Select desired ProjectPro™ nozzle:
• For delicate rinse (lower pressure and higher
flow), for gentle cleaning of cars/trucks, boats, RV’s,
patio furniture, lawn equipment, etc., select yellow
Delicate ProjectPro™ nozzle (Figure 13).
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select orange
General ProjectPro™ nozzle (Figure 14).
• NEVER exchange ProjectPro™ nozzles without locking the
trigger lock on the trigger.
• DO NOT twist ProjectPro™ nozzles while spraying.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
CAUTION
Figure 13 — Delicate Nozzle
Figure 14 — General Nozzle
Section 4: Operation
Delicate
40° Yellow
1650 PSI
2.2 GPM
General
15° Orange
1950 PSI
2.1 GPM
Max
0° Red
2200 PSI
1.9 GPM
Black
Use to apply
detergent
Figure 12 — Nozzle Spray Patterns
Low Pressure
High Pressure