Changing the programme, Intensive drying, Close the door – Neff S65M63N1GB User Manual

Page 17: Switch on on/off switch, Release both buttons, To change the setting, Press start button, 2 cleaning and maintenance, Cleaning and maintenance, Overall condition of the machine

Advertising
background image

Operating the appliance en

17

Aqua sensor

Aqua sensor *

* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, “clean” rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
2–4 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.

Switching on the appliance

1. Turn on the tap fully.
2. Switch on ON/OFF switch (.

The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display )".

3. Press the START button `.

The programme starts running.

Note
For ecological reasons the Eco 50°
programme is preset whenever
the appliance starts. This conserves
environmental resources and not least
saves you money.

Programme sequence indicator

Programme sequence

indicator h

Remaining running time
display

When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )".
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).

Timer programming

Timer programming *

* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital

display )" jumps to

œ:‹‚.

4. Press P + or – button until the

displayed time corresponds with your
requirements.

5. Press START button `, timer

programming is activated.

6. To delete timer programming, press

the P + or – button until )"

œ:‹‹

is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

-/,

Your dishes are being
cleaned.

5/%

Your dishes are being rinsed.

=/<

Your dishes are being dried.

Advertising