Neff S51E50X1GB - Manual (Page 21)

en
21
... when the appliance is
switched on
The appliance does not start.
–
The mains fuse has tripped.
– The appliance plug has not been
inserted.
– The appliance door has not been shut
properly.
... on the appliance
Lower spray arm rotates sluggishly.
–
Spray arm blocked.
The door is difficult to open. *
–
Child-proof lock is activated. The
deactivation instructions are at the
back in the envelope.
* depending on model
Door cannot be closed.
–
Door lock has been activated. To reset,
close the door with greater force.
Cover on the detergent dispenser cannot
be closed.
–
Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
–
Dispenser was damp when filled.
“Check water supply” display )2 lights
up.
–
Tap turned off.
– Water supply interrupted.
– Supply hose kinked.
– Filter in the water supply blocked.
–
Switch off the appliance and pull
out the mains plug.
– Turn off the tap.
– Clean filter in the supply hose.
– Reconnect power supply.
– Turn on the tap.
– Switch on the appliance.
– Water is left in the appliance at the end
of the programme.
–
Waste water hose
is blocked or kinked.
– Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Waste water pump).
– Filters blocked.
– The programme has not yet ended.
Wait until programme
ends or implement “Reset”
function.
The “Check water supply” display )2
flashes rapidly.
–
Water in the safety system.
–
Switch off the appliance and pull
out the mains plug.
– Turn off the tap.
– Call customer service.
Refill indicator for salt )* and/or rinse-
aid )" is not lit.
–
Refill indicator/s switched off.
– Adequate salt/rinse-aid available.
Refill indicator for special salt )* is lit.
–
No salt.
Refill with special salt.
– Sensor does not detect salt tablets.
Use different special salt.
... during the wash cycle
Unusual foam formation.
–
Handwash liquid in the rinse aid
dispenser.
Spilled rinse aid causes excessive
frothing, therefore please remove with
a cloth.
Appliance stops during the wash cycle.
–
Power supply interrupted.
– Water supply interrupted.
Filling valves making striking noises
–
Caused by the installation of the water
line and has no effect on the function
of the machine. Remedial action is not
possible.
Knocking/rattling noise during rinsing
–
Spray arm is striking utensils.
– Utensils not arranged correctly.