M warning, Health hazard, Special salt and rinse aid – Neff S58T69X0GB User Manual

Page 24: Filters, Switching off the appliance, Interrupting the programme, Terminating the programme (reset)

Advertising
background image

en Operating the appliance

24

To change the setting:
1. Press programme button 3.

Each time the button is pressed,
the set value increases by one level;
when the value of

˜:‹ƒ has been

reached, the display jumps back
to

˜:‹‹.

2. Press START button `.

The set value is saved.

3. Close the door.

Switching off the appliance

Short time after the end of the
programme:
1. Open the door.
2. Switch off ON/OFF switch (.
3. Turn off the tap (not applicable if

Aqua-Stop fitted).

4. Remove the utensils when they have

cooled down.

Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.

Interrupting the programme

1. Open the door.
2. Switch off ON/OFF switch (.

The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.

3. To continue the programme, switch

on the ON/OFF switch ( again.

4. Close the door.

Terminating the programme

Terminating the programme

(Reset)

1. Open the door.
2. Press START button ` for

approx. 3 sec.
The numerical display h indicates

‹:‹‚.

3. Close the door.

The programme sequence lasts
approx. 1 min. On the digital display

h is indicated ‹:‹‹.

4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.

Advertising