Neff N21H40S3GB - Manual (Page 3)

en
Please observe:
Electrical connection
The appliance must only be connected
to a properly installed protective contact
socket. The installation of the socket or
replacement of the connecting cable
must only be carried out by a qualified
electrician in accordance with current
regulations.
The appliance must only be connected
with the power cable provided.
Connect the power cable to the back of
the appliance.
Power cables with various plug types are
available from our afterĆsales service.
Do not use multiĆplug adapters, power
strips or extension leads. There is a risk of
fire in the event of overloading.
If the plug is no longer accessible
subsequent to installation, an allĆpole
disconnecting device must be present on
the installation side with a contact gap of
at least 3 mm.
Fitted units
There must be no rear wall to fitted units
which house appliances. There must be a
gap of at least 45 mm between the wall
and the base of the unit, as well as
between the wall and the rear wall of
theunit above.
The ventilation slots and air intake points
must not be covered.
To ensure that they remain uncovered,
also observe the installation instructions
for the appliance above.
Installing the appliance
Connect the appliance to the mains.
Then align the appliance flush with the
units and screw it in place.
Note:
Ensure that the connector lead does not
become trapped or bent.
After installation, the connector lead must
not be in contact with the back or the
base of the appliance.