Neff S72T69X3GB User Manual

Page 26

Advertising
background image

en

26

Warm water connection

Warm water connection *

* depending on model
The dishwasher can be connected to cold
or hot water up to max. 60 °C.
Connection to hot water is recommended
if the hot water can be supplied
by energetically favourable means
and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting

‘:‹‚ allows you

to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the incoming
water) of at least 40 °C and no more than
60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
–

Open the door.

–

Switch on ON/OFF switch (.

–

Hold down programme button # and
press START button )" until

•:‹... is

indicated on the digital display.

–

Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting

•:‹….

–

Press programme button # until the
factory set value

‘:‹‹ is indicated on

the digital display 8.

To change the setting:
–

By pressing the 3 button, you can
switch the hot water setting off

‘:‹‹ or

on

‘:‹‚.

–

Press START button )".
The set value is saved.

–

Close the door.

Electrical connection

–

Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See rating
plate for required fusing 92.

–

The socket must be near the appliance
and freely accessible following
installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side to satisfy
the relevant safety instructions.

–

The connection may be modified by
technicians only.

–

A power cord extension may be
purchased from customer service only.

–

Use only a residual current operated
circuit-breaker which features
the symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.

–

The appliance features a water
damage protection system. Please
note the system will not function
unless the power supply is connected.

Removing the appliance

Also observe the sequence of worksteps
here.
–

Disconnect the appliance from
the power supply.

–

Turn off the water supply.

–

Disconnect the waste water and fresh
water connections.

–

Loosen fastening screws for the
furniture parts.

–

If fitted, remove the base panel.

–

Pull out the appliance, carefully pulling
the hose behind.

Advertising