Adjustment of the taps, Set the control knobs to minimum, Graphic – Neff T22S46N0 User Manual

Page 7: Never remove the valve reinforcing ring, Refit the control knobs, Important, Operating instructions, Burner locations, Semi-rapid burner (up to, Rapid burner (up to

Advertising
background image

7

Adjustment of the taps

1.

Set the control knobs to minimum.

2.

Remove the control knobs from the taps. It has a flexible

rubber valve reinforcing ring. Press with the tip of the

screwdriver to access the tap's adjusting screw.

Never remove the valve reinforcing ring. The valve

reinforcing rings guarantee the watertightness of the

appliance's interior from liquids and dirt, which might

otherwise prevent its correct operation.

3.

Adjust the minimum ring setting by turning the by-pass screw

using a flat head screwdriver.
To adjust the minimum flame for N.G. replace the control

knob onto the spindle, light the gas and turn the control knob

to the small flame position. Screw the adjustment screw anti-

clockwise to estabilish a minimum stable flame position. The

flame should remain alight and not burn back to the injector

when the valve is turned quickly from ‘Full On’ to the

“Minimum flame” position and back a few times. To adjust

the minimum flame position for Universal LPG the screw must

be fully tightened down clockwise.

4.

Refit the control knobs.

If the by-pass screw cannot be accessed, disassemble the

grease drip tray, which is fixed to the rest of the hob using a

clip and screw mounting system. The following steps must be

taken to remove it:

1.

Remove all pan supports, burner caps, diffusers and control

knobs.

2.

Loosen the screws on the burners.

Use the disassembly lever 483196 available from our

Technical Assistance Service. To release the front clips, apply

the lever to the area shown in figure below.

3.

To assemble the grease splash tray again, proceed in the

reverse order to removal.

It is important that all the seals are refitted to form a seal.
Never remove the tap spindle. In the event of a malfunction,

change the whole tap.

Important: After finishing, stick the sticker, indicating the new

gas type, close to the specifications plate.

Operating instructions

Burner locations

1

Pan supports

2

Control knobs

3

Auxiliary burner (up to 1 kW)

4

Semi-rapid burner (up to 1.75 kW)

5

Rapid burner (up to 3 kW)

6

Double-flame wok burner (up to 3.3 kW)

7

Dual double-flame wok burner up to 5 kW

761$8

2

1

761$8

2

1

Advertising