Blue Rhino TM72 - Manual (Page 142)

MAINTENANCE
TM60/72/84/100 02/11 Maintenance Section 5-2
© 2011 Alamo Group Inc.
MAINTENANCE
Before operating your Finishing Mower, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Finishing Mower for transporting or making
adjustments.
Lubrication
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on
normal operating conditions. Severe or unusual conditions may require more frequent lubrication. MntP-R-
0059.
Use Multi-purpose Gear Oil P/N 00786250 for all locations shown. Be sure to clean the fitting thoroughly before
using grease gun. Daily lubrication of the wing driveline slip joint is necessary. Failure to maintain proper
lubrication will result in damage to U-joints, gearbox, and/or driveshaft.
Lubrication Fitting Location
ITEM DESCRIPTION FREQUENCY
1 Gauge Wheel Pivots 10 Hours or daily
2 Wheel Hubs 10 Hours or daily
3 Blade Spindle 10 Hours or daily
4 U-Joints 10 Hours or daily
5 U-Joint Telescoping Member 10 Hours or daily (Not Shown)