Brother 580C - Manual (Page 127)

123
ERROR MASSAGE CAUSE REMEDY
LENGTH LIMIT!
•
The length of one label message
is limited to one meter.
This message appears if a chara-
cter, symbol, diacritical mark, bar
code, space, return or new block
is entered, causing the text to
exceed the one meter limit.
•
This message appears if the
entered text exceeds the one
meter limit when the power is
turned on or while trying to print.
•
This message appears if a
file is recalled and joined to
the current message, causing
the text to exceed the one meter
limit.
•
This message appears if the
RETURN key is pressed in
Format mode, causing the text
to exceed the one meter limit.
•
Delete some of the text or
reduce the character size.
•
Delete some of the text or
reduce the character size.
•
Press the CANCEL key and
delete some of the text before
recalling the file or joining the
working area text and the file.
•
Press the CANCEL key and
delete some of the text before
entering a frame or other gro-
bal format setting.
LINE LIMIT!
•
This message appears if the
number of lines in the text is
greater then the maximum
number of lines possible for
the installed tape.
•
Reduce the number of lines
or install a tape of greater
width.
MEMORY FULL!
•
This machine can store about
3,400 characters in its memory.
This message appears when you
try to store a message that is too
large to fit in the available memory
space.
•
Stop trying to store the mes-
sage or delete an unwanted
file to make room for the new
one.
NO FILES! •
This message appears if you
try to recall or delete a text file
from the memory when none
are currently stored.
•
Do not attempt to recall or
delete a text file.
NO TAPE! •
This message appears if you
attempt to print a label or feed
the tape when a tape cassette
is not installed.
•
Install a tape cassette and
try again.