Whirlpool W10298318RP - Manual (Page 5)

5
INSTALLATION INSTRUCTIONS
1. Move washer close to its final location. Leave room to work
behind washer. Do not remove the shipping bolts.
2. Level washer as described in washer “Installation
Instructions”.
3. Place a covering, such as cardboard or a blanket on the floor,
to avoid damage. Gently lay the dryer down with its side on
the covering.
4. If the dryer has the feet already installed, remove them. Do
not install the dryer feet.
5. Remove the adhesive cover strip from one of the long
rubber pads. Starting from the top of the base and in about
1/2" (13 mm) from the edge (covering the small ridges), press
adhesive side of pad against dryer base. Pads run front
to back.
Repeat installation of remaining rubber pad on other side.
A. Rubber pad
B. Small ridges
6. Lift the dryer back to upright position and move to front
of the washer.
7. Lift the dryer up and set on top of washer so that the back
of the washer and dryer are lined up.
8. Remove the plastic clips (2), brackets (2), and pan-head
screws (4) from the parts bag.
9. Take a plastic clip (C) and with the flat side facing out, push
it down onto the lower edge of the slot (D) in the dryer back.
Repeat on other side.
c
D
10. Place the hooked end of the bracket (E) over the plastic clip
(C). Rotate down against back of washer. Adjust the dryer
forward or backward as needed and attach bracket (E) to
washer with pan-head screws (F). Tighten screws securely.
Repeat on other side.
11. Follow the “Installation Instructions” that came with your
washer and dryer to remove the shipping bolts and complete
the installation.
E
c
F
B
a