Whirlpool AKP 459 IX - Manual (Page 6)

GB5
REPLACING THE OVEN LAMP
To replace the rear lamp (if present):
1.
Disconnect the oven from the power supply.
2. Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on (Fig. 7).
3. Reconnect the oven to the power supply.
N.B.:
-
Only use 25-40W/230V type E-14, T300°C incandescent lamps.
- Lamps are available from our After-sales Service.
IMPORTANT:
-
Do not use the oven until the lamp cover has been repositioned.
FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION
1. Control panel
2. Upper heating element/grill
3. Cooling system (if present)
4. Dataplate (not to be removed)
5. Light
6. Baking ventilation system (if present)
7. Turnspit (if present)
8. Lower heating element (not visible)
9. Door
10. Position of shelves
11. Rear wall
N.B.:
-
At the end of cooking, after the oven has been switched off, the cooling fan may continue to run for a while.
Fig. 6 Fig. 7
INSTRUCTIONS FOR OVEN USE
1
11
5
2
4
7
8
10
9
6
3