Briggs & Stratton PRO8000 - Manual (Page 7)

7
BSPP Generator
2. Stand at control panel end of generator and gently tilt
generator up, high enough to place wooden blocks
beneath cradle.This will allow you to add wheels.
3. Slide axle through holes in brackets provided on
generator cradle.
4. Slide a wheel and flat washer on one end of axle. Make
sure air inflation valve is outward. Place e-ring onto
groove in axle.
5. Place one end of needle nose pliers on bottom of axle
and other end of pliers on top of e-ring. Seat e-ring by
pressing pliers closed.
6. Slide axle through until wheel is tight against bracket.
7. Install wheel, flat washer and e-ring on other side in
same manner as steps 4 & 5. Remove wooden blocks.
8. To aid support leg assembly, rest generator on cradle,
control panel end down.
9. Attach vibration mount to support leg with a 1/4-20 x
1” capscrew and 1/4-20 lock nut.
10. Secure support leg assembly to cradle with M8 x
20 mm capscrews and M8 lock washers. Rest
generator on wheels and support leg.
11. Check that all fasteners are tight and the tires are inflated
to the value marked on the tire or within 15 and 40 psi.
ELECTRIC START
Your unit is equipped with electric start capability but can
be started manually. If you choose not to use the electric
start feature, you do not need to install the negative
battery cable.
Check Battery / Attach Negative
Battery Wire
The sealed battery on the generator is fully charged and
pre–installed except for the negative (black) battery cable.
To install:
1.
Cut off tie wrap securing loose end of negative (black)
cable.
2. Remove nut and washer on negative battery terminal.
3. Slide negative battery cable over screw on negative
terminal (Figure 2).
4. Reattach washer and nut and tighten.
5. Verify that connections to battery and generator are
tight and secure.
Figure 2 — Negative Battery Connection
Positive battery cable
Screw
Negative
battery
cable
Washer
Nut