Instruments and controls 5-25 – Buick 2011 Lacrosse User Manual
Page 143
Black plate (25,1)
Buick LaCrosse Owner Manual - 2011
Instruments and Controls
5-25
The fuel economy can be reset by
pressing SET/CLR while the
Average Fuel Economy display is
showing.
Instantaneous Fuel Economy
The Instantaneous Fuel Economy
display shows the current fuel
economy in either liters per
100 kilometers (L/100 km) or miles
per gallon (mpg). This number
reflects only the fuel economy that
the vehicle has right now and
changes frequently as driving
conditions change. Unlike average
economy, this display cannot be
reset.
Average Vehicle Speed
This display shows the average
speed of the vehicle in miles per
hour (mph) or kilometers per
hour (km/h). This average is
calculated based on the various
vehicle speeds recorded since the
last reset of this value. The average
speed can be reset by pressing
SET/CLR while the Average Vehicle
Speed display is showing.
Timer
This display can be used as a timer.
To start the timer, press SET/CLR
while Timer is displayed. The
display will show the amount of time
that has passed since the timer was
last reset, not including time the
ignition is off. Time will continue to
be counted as long as the ignition is
on, even if another display is being
shown on the DIC. The timer will
record up to 99 hours, 59 minutes
and 59 seconds (99:59:59) after
which the display will return to zero.
To stop the timer, press SET/CLR
briefly while Timer is displayed. To
reset the timer to zero, press and
hold SET/CLR.
Turn-by-Turn
This display is used for the OnStar
or Navigation System Turn-by-Turn
guidance. See the OnStar manual
or the Navigation manual, if the
vehicle has navigation, for more
information.
Vehicle Information Menu
Items
Press MENU on the turn signal
lever until Vehicle Information Menu
is displayed. Use
w x
to scroll
through the following menu items:
.
Unit
.
Tire Pressure
.
Remaining Oil Life
Unit
Move
w x
to switch between
Metric or US when the Unit display
is active. Press SET/CLR to confirm
the setting. This will change the
displays on the cluster and DIC to
either metric or English (US)
measurements.