Bissell 3301 - Manual (Page 7)

Maintenance
7
The key to maximum performance is a clean Filter. Emptying
the Filter after each use, and cleaning it periodically, will help
your Go Vac operate at peak efficiency. Replacement Filters are
available. See below.
1. With Go Vac facing away from you, grasp Dust Cup in right
hand and turn it toward you (toward back of Go Vac).
2. Carry the Dust Cup, with filter in place, to a waste container.
Remove Filter, shake debris from Filter and Dust Cup, then
replace Filter in Dust Cup.
3. Replace Dust Cup by placing it in position and turning it
away from you until it fits securely.
4. Clean exterior surfaces with a soft cloth dampened with
water only. Do not use a strong detergent or other cleaner -
this may damage the finish. Always remove the Go Vac from
the Charging Base or unplug it from the wall outlet before
cleaning the surface.
5. After heavy usage, you may clean the Filter by gently
rinsing it in a bowl of water and mild dish detergent.
Rinse thoroughly under running water and make certain
it is completely dry before replacing it. You may also
purchase replacement Filters.
Replacement Filters
Use only BISSELL Filters in your BISSELL Go Vac. If your Filter
becomes damaged or becomes too dirty to wash, you may
purchase new filters with the order form in this User’s Guide,
or by calling
BISSELL Consumer Services
1-800-237-7691
Monday - Friday 8 a.m. — 7 p.m. EST
Saturday 9 a.m. — 2 p.m. EST
Or visit our website @ www.bissell.com
To empty your filter:
WARNING:
Never operate your
Go Vac without the
Filter in place. Doing
so may damage the
motor and void the
warranty.
WARNING:
This product contains
a rechargeable nickel cadmium battery
(sometimes referred to as a “Ni-Cad”
battery) pack. According to Federal and
State regulations, proper removal and
disposal of Ni-Cad batteries is required.
For removal of the battery pack in your
Go Vac, see instructions below:
1. IMPORTANT: Unplug charger.
2. Remove screws (10) holding Product
Housing together (see diagram).
3. Separate Housings and locate Battery
Pack in bottom/center of unit.
4. Remove wire connectors from the
Battery Pack.
5. Keep Battery Pack together - DO NOT
separate individual batteries. For specific
disposal instructions of batteries,
please contact:
RBRC (Rechargeable Battery Recycling
Corporation) 1-800-822-8837.
6. Discard remainder of product.
Battery Removal and Disposal
10 Screws