Brother TZTAPE PT-300 - Manual (Page 42)

-40-
When “- ”, “# ”, “## ” or “### ” is set, press + to
feed the tape after the label is printed and before the tape is cut. If the
tape is not fed before being cut, some of the printed characters may be
cut off. (See the illustrations below.)
Example ● When “####” is set, the tape is automatically fed 1”(24mm) after the
label is printed. If the tape is cut without being fed, a label like that
shown in the illustration below is produced.
● When “- ” is set, the tape is not automatically fed after the label is
printed. If + is pressed to feed the tape and the tape
is cut, a label like that shown in the illustration below is produced.
● When “# ” is set, 4mm of the tape is automatically fed after the label is
printed. If + is pressed to feed the tape and the tape
is cut, a label like that shown in the illustration below is produced.
Please cut the tape on the “:” mark with scissors.
Note: CODE SPACE
FEED
1”
(24mm)
1”
(24mm)
CODE SPACE
FEED
1”
(24mm)
CODE SPACE
FEED
1/6”
(4mm)
1”
(24mm)
1/6”
(4mm)