Behringer Eurorack Pro RX1602 - Manual (Page 8)

8 EURORACK PRO RX1602 User Manual
3.4 Small live setup
Compact and powerful, feature-rich equipment is optimal for musicians who
spend a lot of their time on the road. Fig. 3.4 shows an example of a compact
solution for keyboard and vocal amplification, whereby a singing guitar player or
an additional musician can easily be integrated into the mix.
B-2 PRO
ULTRAGAIN PRO MIC2200
COMPOSER PRO-XL MDX2600
EURORACK PRO RX1602
Keyboard
EUROPOWER EP2000
Main
outputs
L R
Fig. 3.4: Expandable small live setup
4. Installation
4.1 Rack mounting
The BEHRINGER EURORACK PRO RX1602 requires one height unit (1 HU) for being
installed into a 19" rack. Please allow at least an extra 4" of space for the
connectors on the rear panel.
Also, please make sure that sufficient ventilation of the unit is provided
for, and never put the rack mixer onto an amp or similar equipment to
avoid overheating.
Please use M6 machine screws and nuts to install your RX1602 into a rack.
4.2 Audio connections
You will require several types of cables for the various kinds of connections
possible. The following illustrations show you how to wire different cables.
Always use high-quality cables.
The audio inputs of the RX1602 are electronically balanced to avoid
hum problems.
Of course, you can also connect equipment featuring un-balanced outputs.
To this end, use either mono jacks or connect ring and sleeve of the stereo jack
(bridge pin 1 and pin 3 when using XLR connectors).
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
Unbalanced ¼" TS connector
tip
(signal)
Fig. 4.1: 1/4" TS connector