Bel Canto Design PRePro - Manual (Page 12)

Page 1 2 © 2002/2003 bel canto design, Ltd. PRePro User’s Guide rev1103
1 QUICK SETUP SPEAKER SIZE
2 QUICK SETUP SPEAKER DIST
3 INPUT ASSIGNMENT
4 TUNER/PAL/NTSC SETTING
5 BASS TRIM
6 CALIBRATION
7 COMPRESSION
OFF
8 STATUS DISPLAY ON
9 DVD AUDIO FULLRANGE NO
0 RESET TO DEFAULTS NO
EXIT
1 QUICK SETUP SPEAKER SIZE
2 QUICK SETUP SPEAKER DIST
3 INPUT ASSIGNMENT
4 TUNER/PAL/NTSC SETTING
5 BASS TRIM
6 CALIBRATION
7 COMPRESSION
OFF
8 STATUS DISPLAY ON
9 DVD AUDIO FULLRANGE NO
0 RESET TO DEFAULTS NO
EXIT
DVD Audio Full Range
Reset to Defaults
This sets the analog bass management selection
for the 7.1 audio through-put. When in DVD
AUDIO FULLRANGE with YES selected there are
no filters in the path.
When DVD AUDIO FULLRANGE shows NO, fil-
ters will be set according to the settings in the
QUICK SETUP SPEAKER SIZE menu.
1. From MAIN MENU press selection 9.
2. Press SELECT to toggle between the NO
(bass filters) or YES (no filters) setting.
3. Press EXIT to get back to the MAIN MENU.
The Analog bass filters are fixed at an 80Hz
setting.
This will set the unit to all factory defaults, we
recommend not to use this unless there
is trouble with any of the settings you
have made.
This is a good way to get the unit to baseline
condition or when there has been an update to
the unit firmware.
1. From MAIN MENU press selection 0.
2. Press SELECT to toggle between YES to
reset or NO to not reset.
3. Press EXIT.