Brick Computer CB-102A - Manual (Page 52)

- 45 -
EasyLink TM
EasyLink TM is a unique Brickcom function which allows users to assign a unique domain name
to their network camera’s IP address. There is no need to configure the router to open up
ports or remember hard-to-memorize IP addresses. When this function is enabled, users
can log onto [uniquedomainname].mybrickcom.com to view the camera’s web GUI and live
view.
1. Check the box to enable EasyLink
TM
.
2. Enter a unique domain name whose length must be between 5-32 characters. Verify
that the domain name is available.
3. Select a desired amount of time from the Refresh Time drop-down menu to confirm the
connection status.
Click Apply to apply settings or Cancel to cancel changes.
NOTE - The EasyLink function will not work if the following conditions occur:
1. The camera cannot be located behind a double NAT network.
2.
The camera’s IP address cannot be assigned to specific port numbers using the
router’s port forwarding.
3. EasyLink uses UPnP to exchange port information with the router. The camera must
connect to the internet through a router which supports UPnP.