Philips SHAVER Series 3000 afeitadora eléctrica en seco User Manual
Page 7
- Do not use the shaver or the adapter if it is damaged, as this may cause
injury. Always replace a damaged adapter with one of the original type.
- Use and store the appliance at a temperature between 10°C and 35°C.
- Always place and use the shaver on a surface that is fluid-resistant.
- Only use the adapter and accessories supplied.
- Always put the protection cap on the shaver to protect the shaving
heads when you are travelling.
compliance with standards
- This Philips appliance complies with all applicable standards and
regulations regarding electromagnetic fields (EMF).
general
- This shaver is suitable to be cleaned under a running tap.
- The adapter is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
using the shaver
Note: This shaver is not rechargeable and can only be used from the mains.
1
Put the small plug in the shaver.
2
Put the adapter in the wall socket.
3
Press the on/off button once to switch on the shaver.
4
Move the shaving heads over your skin. Make circular movements.
- Do not make straight movements.
- Your skin may need 2 or 3 weeks to get accustomed to the Philips
shaving system.
5
Press the on/off button once to switch off the shaver.
6
Clean the shaver (see chapter ‘Cleaning and maintenance’).
cleaning and maintenance
Remove the detachable cord from the handheld part before cleaning this
part in water.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
- Clean the shaver after every shave for optimal shaving performance.
- Regular cleaning guarantees better shaving performance.
- For the best cleaning results, we advise you to use the Philips Cleaning
spray (HQ110).
- Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
Note: Water may leak from the socket at the bottom of the shaver when you
rinse it. This is normal and not dangerous because all electronics are enclosed
in a sealed power unit inside the shaver.
English
7