Briggs & Stratton 350000 - Manual (Page 14)

Document: - page 14 (Black)
Screen angle and frequency: 45.0000, 150.0000
14
MAINTENANCE
CLEANING DEBRIS
CAUTION: Do not use water to clean engine parts.
Water could contaminate fuel system. Use a brush
or dry cloth.
Daily or before every use, clean accumulated debris from
engine. Keep linkage, springs and controls clean. Keep
area around and behind muffler free of any combustible
debris.
Engine parts should be kept
clean to reduce the risk of
overheating and ignition of accu-
mulated debris. This is especial-
ly important if cutting tall grass.
WARNING
Linkage, Springs
and Controls
CLEAN
ООО ОО
О
Finger
Guard
Rotating
Screen
CLEAN
CLEAN
Muffler and
Spark Arrester
CLEAN
SPARK
ARRESTER
ADJUSTMENTS
CONTROL ADJUSTMENTS
WARNING
Prevent unintentional starting.
Before performing adjustments:
•
Remove spark plug wires from spark plugs.
•
Disconnect battery at negative terminal (only
engines with electric start).
TO ADJUST REMOTE CHOKE CONTROL
[1] Remove air cleaner.
[2] Move choke control to CHOKE or START position.
(Carburetor choke should be completely closed.)
[3] If not, loosen casing clamp screw.
[4] Then move casing, wire and engine choke lever in
direction shown until choke is completely closed.
[5] Tighten casing clamp screw. Replace air cleaner.
CHOKE
CLOSED
SCREW
WIRE AND
CASING PULL
TO CHOKE
TO ADJUST REMOTE THROTTLE CONTROL
If the engine does not start or if it runs roughly, the remote
throttle control may need adjustment. See your authorized
Briggs & Stratton dealer or follow the instructions below.
[1] Remove air cleaner. Move throttle control to FAST.
(Swivel should be against throttle stop.)
[2] If not, loosen casing clamp screw. Move casing
and wire in direction shown by arrow until swivel is
against throttle stop.
[3] Tighten casing clamp screw. Replace air cleaner.
CASING
CLAMP
SCREW SWIVEL
EXHAUST
MANIFOLD
THROTTLE STOP