Philips Aluminium Collection Batidora de mano - Manual (Page 12)

12
Why does the appliance suddenly stop working?
Some hard ingredients may block the blades.
Release the on/off button, detach the motor unit
and remove the ingredients that block the blades.
Charging:
Why do the charging lights flash red?
The safety switch does not work properly. In this
case, it is not possible to switch on the appliance
and the charging lights flash red. Set the safety
switch to the off (upper) position and switch
on the appliance again. If the appliance still does
not work after you have set the safety switch to
the off position, contact your Philips dealer or a
service centre authorised by Philips.
Why do the charging lights light up red
continuously?
The overload protection has switched off the
appliance because the motor is too hot. The
charging lights light up red for 16 seconds. Let the
appliance cool down before you continue to use
it. If the appliance still does not work, contact your
Philips dealer or a service centre authorised by
Philips.
Why does the bottom charging light flash blue?
The batteries are running low. Recharge the
batteries (see chapter ‘Getting started’, section
‘Charging your hand blender’).