Bissell 1867 - Manual (Page 7)

O
peration
7
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Getting ready
The mop pad may have already come attached
to the swivel head, if not follow steps 1A and
1B below.
1. Attach mop pad.
A. Set swivel head in mop pad, making sure
toggle is located on the back.
B. Tighten mop pad by pulling on elastic cord
while pressing on toggle.
2. Fill the water tank
A. Remove tank by lifting straight up and away
from unit.
B. Unscrew cap at bottom of water tank and
remove the insert assembly.
C. Fill water tank with water. For best results,
water should be at room temperature.
D. Replace insert assembly and cap, tighten
until snug.
E. Replace water tank by lining up vertical
guides and gently sliding tank into place.
3. Twist the quick release cord wrap clockwise to
unwrap the power cord completely and plug into
a 120-Volt grounded outlet as described on the
Important Safety Instructions, page 3.
4. The ready light will illuminate when the Steam Mop
is ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior to cleaning
with the Steam Mop.
1A 1B
2A 2B
2E
ug120-4065_1867_908.indd 7 ug120-4065_1867_908.indd 7 9/26/08 3:32:09 PM 9/26/08 3:32:09 PM