Philips Lumea Sistema de eliminación de vello IPL - Manual (Page 16)

5 After the skin test, wait for 24 hours and check your skin for
any reaction. If the skin shows reactions, choose the highest setting
that did not result in any skin reaction for subsequent use.
Subsequent use
1 Before every treatment, clean the removable window, filter glass and
metallic surface of Philips Lumea.
2 Press the on/off button to switch on the appliance.
, Intensity light 1 goes on automatically to indicate that the appliance
is switched on at default intensity 1.
Note: It is normal that the appliance becomes warm during use.
3 Start each treatment by selecting the light intensity very carefully,
based on your skin’s sensitivity and comfort at that moment.
Your skin may react differently on different days/occasions for a number of
reasons. See section ‘Possible side effects and skin reactions’ in this chapter
for more information.
4 Press the % button to increase the intensity. To lower the intensity,
press the ^ button.
, Every time you press the button, the corresponding intensity
light starts to flash. This takes a few seconds.
5 Place the appliance perpendicularly on the skin so that the
removable window and the safety ring are in contact with the skin.
EngliSh
16
4203.000.6357.3.indd 16 27-04-10 15:00