Boston Acoustics GTA 1005 - Manual (Page 3)

C
o
n
n
e
c
tio
n
s
/
C
o
n
tr
o
ls
3
Status LED
The Boston Logo will illuminate “Blue” under normal operating conditions.
The LED will illuminate “Red” during start-up and under fault conditions. If the
LED is still red after start-up, please refer to troubleshooting on page 10.
RCA Input (Left and Right)Speaker Level Input
Speaker Level Input
Crosssover Filter Switch (HP / Off / LP)
Gain (250mv to 5.0v - continuously variable)
Crossover Frequency Adjustment (50Hz to 200Hz - continuously variable)
Q-Tune
™ “Q” Adjustment (0.707 to 1.6 - cont. variable)
Lowpass Crossover Adjustment (50Hz to 150Hz - cont. variable))
Q-Tune
™ Highpass (Subsonic) Adjustment (10Hz to 50Hz - cont. variable)
GTA-RSL Port (Remote Gain)
Speaker Output Block (Front and Rear Speakers)
Speaker Output Block (Subwoofer)
Status LED (Blue = Normal / Red = Fault Mode)
Fuses (Replace with same value only, refer to specifications on page 2)
Power Block (12v / Remote / Ground)
13 14 15
13 14 15
13 14 15
13 14 15
4 4 7 1 2 6 12 10 11 13 14 9 2 1 3 5 4 1 2 3 5 8
Connections and Controls
Speaker Level Input Cable
GTA amplifiers offer a dedicated speaker level input for ease installation into
factory systems when an RCA (low level) signal is not available. Wiring code for
the cable is industry standard;
White Solid = Left Positive White w/ Black Stripe = Left Negative
Gray Solid = Right Positive Gray w/ Black Stripe = Right Negative
Warning: Do not connect both Speaker Level and RCAs into the amplifier at the
same time as damage to the amplifier may occur.